Bluetooth And Fm Radio Self Tests In Phoenix - Nokia RM-596 Service Manual

RM-596
BB Troubleshooting and Manual Tuning Guide
WLAN test coverage
The tests listed in the table below should be performed to verify whether WLAN is functional. WLAN should
be re-tested after repair.
Test
WLAN Self Test: ST_WLAN_TEST
Bluetooth Functional Test: BER test
with BT-Box or functional test with
another Bluetooth device
WLAN TX Tuning
The self tests run from Phoenix software are used for fault diagnosis.
If Phoenix software is not available, the functional tests with phone accessories are sufficient to verify the
functionality of WLAN.

Bluetooth and FM radio self tests in Phoenix

Prerequisites
A flash adapter (or phone data cable) connected to a PC with Phoenix service software is required.
Steps
1. Place the phone in the flash adapter or connect data cable to phone.
Phoenix service software.
2. Start
3. Choose File → Scan Product.
4. From the Mode drop-down menu, set mode to Local.
5. Choose Testing → Self Tests.
Self Tests window check the following Bluetooth and FM radio related tests:
6. In the
• ST_LPRF_IF_TEST
• ST_LPRF_AUDIO_LINES_TEST
• ST_BT_WAKEUP_TEST
Issue 2
Test Coverage
WLAN SPI and control interface
(data interface and control of
WLAN)
Antenna connection from module,
including filter
Checks WLAN TX path up to
module output and calibrates the
new module if fitted
COMPANY CONFIDENTIAL
Copyright © 2010 Nokia. All rights reserved.
Repair solution
Replacement of BOB module
Replacement of BOB module or
antenna components
Replacement of BOB module or
antenna components
Page 3 – 63