Troubleshooting - Olympus m:robe MR-100 User Manual

Troubleshooting

Troubleshooting
Before sending the product for repair, refer to the following checklist to resolve the problem. If the problem
persists, contact your nearest Olympus service center.
In addition, be sure to back up the data in your m:robe before sending this product for repair or service. Writing
to the hard disk or deleting data etc., may be necessary during the repair or service. Due to copyright
restrictions, we cannot copy stored data for repair or service. Restoring the data is not possible. We also
recommend backing up your data often, by synchronization, to prevent data loss problems.
Problem
The power cannot be
turned on.
The player turns off
automatically.
Nothing is on the display.
The display is not clear.
The display and the LED
lights are turned off.
The display does not turn
on.
EN-50
Cause
The HOLD function is set
to ON.
OFF TIMER is set.
The Auto Off function is
activated.
The battery is empty.
The battery is empty.
The LCD brightness setting
is too low.
The backlight is set to turn
off.
The HOLD function is set
to ON.
Resolution
Slide back the HOLD
switch to release the
HOLD function.
The POWER is turned off
automatically after the
setting time of OFF
TIMER has elapsed. Set to
"OFF" to disable the OFF
TIMER setting.
3 minutes after playback
stops, the power turns off
automatically.
Press the POWER to turn
the device on.
Charge the battery with the
supplied AC adapter.
Charge the battery with the
supplied AC adapter.
Adjust settings of the LCD
CONTRAST.
Set the desired time or
change "BACKLIGHT" to
"ON".
Slide back the HOLD
switch to release the
HOLD function.
Page
gpage 28
g page 46
g page 27
gpage 18
gpage 18
gpage 46
gpage 46
gpage 28