Lower Plate - Panasonic MC-UL424-00 Service Manual

4 SERVICE PROCEDURES - NOZZLE (MC-UL424)
4.1.

Lower Plate

4.1.1. Removal
1. Turn off and unplug vacuum cleaner.
2. Lay vacuum cleaner with bottom facing upwards and nozzle
flat
3. Remove nozzle hose from body by (1) pressing in locking
tab and (2) sliding up and out of retaining slot.
4. Remove four (4) screws from the nozzle cover.
5. Place the vacuum cleaner in the upright position standing
on the handle. This will minimize wheel interference when
removing the lower plate.
6. Remove the lower plate by rotating upward as shown. Use
caution as motor shaft may be hot.
4.1.2. Installation
1. Place the vacuum cleaner in the upright position standing
on the handle. This will minimize wheel interference when
removing the lower plate.
2. Reinstall lower plate by (1) aligning tabs with the slots in the
nozzle and (2) rotating the lower plate to installed position.
3. Lay vacuum cleaner with bottom facing upwards and nozzle
flat.
4. Reinstall four (4) screws into lower plate.
5. Route the nozzle hose bracket wi the retaining bracket on
body and slide down until it clicks in place.
6. Return the vacuum cleaner to the upright position before
plugging into an electrical outlet.
19
MC-UL424-00 / MC-UL426-00