Wiring The Receiver - Panasonic CZ-RWSU2 Installation Instructions Manual

Hide thumbs Also See for CZ-RWSU2:

Instruction manual (23 pages)

Instruction manual (203 pages)

Operating instructions manual (202 pages)

Table Of Contents

Table of Contents

Unidirectional cassette model for high ceilings/Unidirectional ceiling cassette model

1 While spreading the tabs of the cover, pull it out from the panel to the front. (Fig. A)

2 Pass the lead wire through the panel and install the receiver in the hole in the panel. (The projecting parts of the

receiver hold it in the hole in the panel)

3 Press the lead wire from the receiver in along the rib on the back of the panel. If installing to a unidirectional high

ceiling cassette, pass it through the cutout. (Fig. B)

4 Install the panel on the indoor unit.

5 Fasten the lead wire sticking out from the panel with the cable clips on the inside of the indoor unit. (Fig. C)

6 Draw the lead wire into the electrical box through the hole on the bottom and connect it to the remote control

terminal strip.

If installing to a high ceiling unidirectional cassette, fasten the wire at the latch of the fan casing with the enclosed

cable tie. (Fig. D)

Fig. A

Pull off to the

front

Fig. C

High ceiling unidirectional

cassette

<Note 1> If the wiring for the receiver is bundled with other wires, such as the incoming line, it may cause a

malfunction, so avoid putting them together.

<Note 2> Fasten the lead wire securely so it does not get wrapped up in the fan.

<Note 3> If something causes the unit's power source to make noise it will be necessary to resolve the problem,

such as by installing a noise ﬁ lter.

For more information about wiring or test operation, refer to Wiring the Receiver and Test Run.

Wiring Diagram

Connections

Connect the wires from the receiver to the remote control terminal strip on the indoor unit. (Polarity does not matter)

Spread

Cover

Press the

lead wire

Spread

Fig. D

Unidirectional ceiling

cassette

Cable clips