Cz-Rwsu2; Accessories; Installing The Receiver - Panasonic CZ-RWSU2 Installation Instructions Manual

CZ-RWSU2

No.

Accessories

1 Receiver
2 Remote Control
3 Remote Control Holder
The receiver can only be installed on the corner indicated in Fig. A, so consider how the panel will face when it is
installed on the indoor unit.
1 Remove the air inlet grill.
2 Remove the screw holding the adjustable corner cap, slide the cap to the side and remove it. (Fig. B)
Fig. A
Receiver installation Location
Box with Indoor
Unit's Electrical
Parts
3 To pass the wire through the panel, bend back the clip on the hexagonal hole (diagonal line) and then pass wire
protruding from the wireless receiver through the grill. (Fig. C)
4 After wiring according to the directions in Wiring the Receiver Unit below, leave enough wiring so the receiver's
adjustable corner cap can be removed and fasten the cable clamp with its screw. (Fig. C)
5 Hang the string on the corner cover onto the pin on the ceiling panel as shown in the diagram. Then slide the corner
cover onto the ceiling panel until the three clips are correctly located, and then fi x it in place with the screws. (Fig. D)
Make sure the wire is not caught.
Refer to the installation instructions supplied with the panel.
Fig. C
Bend back the clip (diagonal
line) with a screwdriver or
similar implement to allow the
wire to pass through.
<Note 1> If the wiring for the receiver is bundled with other wires, such as the incoming line, it may cause a
malfunction, so avoid putting them together.
<Note 2> If something causes the unit's power source to make noise it will be necessary to resolve the problem,
such as by installing a noise fi lter.
For more information about wiring or test operation, refer to Wiring the Receiver and Test Run.
4
Accessories
Quantity No.
1
1
1

Installing the Receiver

Adjustable Corner Cap
Fig. B
Screw
Fix it in place with
the cable clamp.
Accessories
4 Dry-cell Batteries
5 Users Manual
6 Truss Self-Tapping Screws
4 × 16
7 Cable clamp
Fig. D
Pin
Screw
fi xed
Make sure the three clips on the corner
cover are located over the holes on the
ceiling panel, and then fi x it in place
with the screws supplied.
Quantity
2
1
2
1
Ceiling Panel
Adjustable Corner Cap