Wire The Indoor Unit; Reattach The Upper Part Of The Remote Controller; Wiring Specifications - Panasonic CZ-01RT11P Installation Manual

3. Wire the indoor unit

1 indoor unit
2 lower part of the remote controller
3 upper part of the remote controller
4 wired from the rear
5 wired from the top
6 notch the part for the wiring to pass through
with nippers, etc.
Connect the terminals on top of the upper part of the
remote controller (P1, P2), and the terminals of the
indoor unit (P1, P2). (P1 and P2 do not have polarity.)
NOTE When wiring, run the wiring away from
the power supply wiring in order to avoid
receiving electric noise (external noise).
Wiring Specifications
Wiring type
Size
NOTE Peel the shield for the part that has to
pass through the inside of the remote
controller case. Refer to figure 3 (1).
Installation manual
2
(Refer to figure 6)
2 wire
2
0.75–1.25 mm
4. Reattach the upper part of the
remote controller
Be careful not to pinch the wiring when
attaching.
Refer to figure 4:
First begin fitting from the clips at the bottom.
NOTE 1. The switch box and wiring for connec-
tion are not included.
2. Do not directly touch the PC board
with your hand.
If controlling one indoor unit with two
remote controllers
Change the MAIN/SUB changeover switch setting as
described below (Refer to figure 5).
1 Main remote controller (factory set)
2 Sub remote controller
Set one remote controller to "main", and the other to
"sub".
NOTE 1. If controlling with one remote controller,
be sure to set it to "main".
2. Set the remote controller before turning
the power supply on.
CZ-01RT11P
Remote controller
4PW12543-1