Cz-Rwsc2; Accessories; Installing The Receiver - Panasonic CZ-RWSU2 Installation Instructions Manual

CZ-RWSC2

No.

Accessories

1 Receiver
(Enclosed 200 mm wiring)
2 Remote Control
Remote Control Holder
3
Dry-cell Batteries
4
When using a separately installed receiver as a built-in model, install it to the switch box (fi eld
supply) shown in the diagram on the right, which has been built into the wall on site in advance.
1 Remove the face plate of the receiver by slipping a slotted screwdriver or the like into the cutout on the bottom.
2 Install the receiver with the 2 enclosed small M4 screws.
3 Connect the receiver's wiring (2 cores) with the wiring from the indoor unit. (Refer to the chapter on wiring the
receiver)
When wiring receivers, be sure to double-check the terminal numbers of the indoor unit before connecting them so
there are no mistakes in the wiring. (Damage will occur if high voltage [e.g. supply voltage] is applied)
4 Attach the face plate.
M4 × 25 Small screws (2)
12
Accessories
Quantity

Installing the Receiver

Receiver Unit
Cutout
Face Plate
No.
1 4 Users Manual
5 Truss Self-Tapping Screws
4 × 16
1 6 Small screw
1 7 Wood screw
2 Cable tie
8
Spacers
Single outlet switch box (no cover)
Accessories Quantity
1
2
2
2
1