Wiring The Receiver; Test Operation; Setting Address Switches - Panasonic CZ-RWSU2 Installation Instructions Manual

Hide thumbs Also See for CZ-RWSU2:

Instruction manual (23 pages)

Instruction manual (203 pages)

Operating instructions manual (202 pages)

Table Of Contents

Table of Contents

Wiring Diagram

Indoor Unit

Terminal Strip for

Wiring Remote

Controls

Connections

・ Connect the wires from the receiver to the remote control terminal strip on the indoor unit. (Polarity does not

matter)

Implementing a Test Run

1. Turn the #1 DIP switch [S003] on the receiver's PCB

from OFF to ON and operate the wireless remote

control with its Start/Stop button.

2. During a test run, all display lamps on the display will

light up.

3. During a test run, it is not possible to adjust the

temperature.

4. After completing a test run, be absolutely sure to turn

the #1 DIP switch from ON to OFF and make sure none

of the display lamps are blinking. Also, replace the PCB

cover back as it was and fasten it; while holding the

wiring with the cable clamp, tighten its screw.

<Note 1> This is hard on the device, so only use this for

the test run.

<Note 2> After turning on the power, the unit will not

receive any commands from the remote control

for about 1 minute. This is not an error. (In fact

it does receive signals, but they are cancelled.)

When more than one receiver and remote control are installed in the same room, setting up addresses allows

them to avoid interfering with each other.

Refer to the Users Manual for information on how to change the addresses of the remote controls.

Changing the address of a receiver can be done after removing the screw to the receiver's PCB cover. Once the

change is complete, put the cover back in place; while holding the wiring with the cable clamp, tighten its screw.

Address Display

on the Remote

Control

Position of the

It doesn't matter

Receiver's

where the receiver's

Address Switch

address switch is.