Safety Helmet Hook; Fuel Tank Cap; Brake; Engine Brake - Sym Tonik 50 Instruction Manual

§SAFETY HELMET HOOK§
Stop the motorcycle, and hook the safety helmet
chin belt the hook.
CAUTION:
Do not hang the safety helmet onto this hook
when riding to avoid damaging motorcycle and
loosing safety helmet's function.
§

FUEL TANK CAP

1.Insert the key into the main switch, and turn the ignition switch
key to the" fill gasoline" position counter-clockwise, then the
fuel tank cap can be removed.
2. Do not fill above the fuel upper limit when refueling.
3. Align the "△ "mark on the cap with the "△ "mark on the fuel
tank, then close the fuel tank cap .
CAUTION:
Main stand should be put down on the ground, engine should be shut off and flames should be
strictly prohibited to ensure safety when refueling.
Do not fill above fuel upper limit when refueling. Otherwise, fuel will flow out through a hole on the
cap that may damage the body's painting, in serious cases, it may cause a fire to burn down the
motorcycle.
Make sure the cap has been tighten properly.
§BRAKE§
Avoid unnecessary sudden braking.
Use front and rear wheel brakes simultaneously when braking.
Avoid brake continuously for a long period of time because that may overheat the brakes and reduce
its braking efficiency.
Slow down and brake early when riding in rainy days on slippery roads. Never apply the brakes
suddenly to prevent skidding and falling.
Using only the front brake or the rear brake increases the risk of falling because the motorcycle is
tend to pulled to one side.

《Engine Brake》

Return the throttle valve handle back to its original position, and apply engine brake.
It is necessary to apply brake both for front wheel and for rear wheel intermittently when riding on a long or
stiff slope.
7. USE OF EACH COMPONENT
10
§
For Front Wheel For Rear Wheel
Hook
Fuel tank cover