Saddle Lock; Safety Helmet Hook - Sym JET 50 series Owner's Manual

l High/Low Beam Switch (If installed)
This is the high and low beam of headlight switching switch. Press this switch to switch between high
and low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
l Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to "ON", and slide the turn signal switch to left or right. Then, the turn signal lights
will flash.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.
l Horn Switch
Press this button down when ignition switch is in the "ON" position, the horn will sound.
CAUTION:
Ÿ
Do not press this button when you are in the no horn area.

SADDLE LOCK

l Unlock:
Insert your ignition switch key into the lock on the lower left of the saddle, and turn the key to the right.
Then, the saddle can be lifted up.
l Lock:
Press the saddle down and push it locks automatically.
CAUTION:
Ÿ
Please do not put the key into the storage compartment after saddle is unlocked to prevent the key
from being locked inside and can not be removed when the saddle is locked.
Ÿ
Be sure to remove the key after the saddle has been locked

SAFETY HELMET HOOK

Ÿ
Open the saddle, and hook the safety helmet chin belt onto the hook, and then lock the saddle.
CAUTION:
Ÿ
Please do not hang your safety helmet as usual on the hook when driving, to prevent it from
damaging the vehicle and affecting your driving safety.
• Engine Stop Switch
Switch to this position to turn off the engine when a state of emergency.
Switch to this position and the engine can be started.
• Passing Switch (If installed)
Turn ignition switch "ON" and press this button down. Then, the high beam of headlight will come on
immediately to warn the driver of the vehicle ahead that you intend to overtake him/her. (For overtaking, high
beam indicator will come on at this time) This button will return to original position after releasing
7. Use of each component
15