Location And Clearances; Ventilation Openings - Napoleon NZ6000-1 Installation And Operating Instructions Manual

Hide thumbs Also See for NZ6000-1:

Table of Contents

3.1

LOCATION AND CLEARANCES

DO NOT INSTALL INTO ANY AREA HAVING A HEIGHT LESS THAN 7 FEET (2.1M) (CEILING OF

ENCLOSURE TO APPLIANCE BOTTOM, EXCLUDING HEARTH HEIGHT).

The appliance is shipped with a set-up face that is 1/8" (38m) larger

on the top, bottom and each side than the faceplate. Leave the set-up

face in place to act as a template when installing the ﬁ nishing face.

IMPORTANT

This appliance, fully dressed, weighs 850 lbs (386kg). Ensure there is

adequate ﬂ oor support for the appliance, chimney and facing material.

Some material could weigh thousands of pounds.

We recommend that the appliance be secured to the ﬂ oor in

all cases.

Using the door opening as a datum, level the appliance by

shimming underneath the appliance. Remove and discard the

lifting handles. Bend the tabs down and secure the appliance to

the ﬂ oor.

The appliance enclosure must be provided with sufﬁ cient air circulation to avoid a ﬁ re hazard. Install ventilation

grilles (minimum openings of 40 sq. inches (0.03 sq. meters)) at both ﬂ oor and ceiling levels of the enclosure.

These grilles must not restrict the ﬂ ow of heat by more than 25%. Do not install into any area having a

height less than 7 ft (2m) (ceiling of enclosure to appliance bottom, excluding hearth height). The location

of windows, doors and the trafﬁ c ﬂ ow in the room where the stove is to be located should be considered. If

possible, you should choose a location where the chimney will pass through the house without cutting a ﬂ oor

or roof joist.

Table of Contents