If A Problem Arises - Olympus Stylus Verve Advanced Manual

If a problem arises

Possible cause
The camera does not respond or the monitor does not turn on
The power is off.
The battery is exhausted.
The battery is temporarily
unable to function because of
the cold.
There is condensation inside
the camera.
The camera turned off auto-
matically in the shooting mode.
The camera turned off auto-
matically in the playback
mode.
The camera is connected to a
computer.
You used a card that had been
formatted on a computer.
No picture is taken when the shutter button is pressed
The card is full.
The flash is charging.
The picture is being written to
the card.
The memory gauge is full.
*1 See the separate Basic manual provided.
Turn the camera on.
Charge the battery.
Warm the battery by putting it
in your pocket for a while.
Turn the camera off and wait until
it dries before turning it on again.
To save battery power, the cam-
era automatically enters the sleep
mode after about 3 minutes of no
activity. Press any button such as
the zoom button.
To save battery power, the
camera automatically enters
the sleep mode. Turn the cam-
era on again.
The camera will not operate while
it is connected to a computer.
The camera does not work properly
This may damage the card or
the pictures files on the card. It
may also make the recording
time exceptionally long or pre-
vent playback. Format the card
with the camera.
Erase unwanted pictures or
insert a new card. Before eras-
ing, transfer all important pic-
tures to a computer.
Wait until the flash charging
lamp stops blinking.
Wait until the red lamp on the
camera body stops blinking.
Wait until there is room in the
memory gauge.
Corrective action
Ref.
page
*1
*1
–
–
*1
*1
–
6
P.107
*1
P.79,
80,
P.150
P.24,
173
P.173
*1
169