Olympus Stylus 850 SW Instruction Manual page 58

When you get an error message on the camera...
Monitor indication
q
CARD ERROR
q
WRITE PROTECT
>
MEMORY FULL
q
CARD FULL
L
NO PICTURE
r
PICTURE ERROR
r
THE IMAGE
CANNOT BE
EDITED
CARD-COVER
OPEN
g
BATTERY EMPTY
CARD SETUP
CLEAN CARD
FORMAT
SET
MEMORY SETUP
POWER OFF
MEMORY FORMAT
SET
NO CONNECTION
NO PAPER
58
NO INK
EN
Possible cause
There is a problem with the
card.
Writing to the card is
prohibited.
The internal memory has no
available memory and
cannot store any new data.
The card has no available
memory and cannot store
any new data.
There are no pictures in the
internal memory or on the
card.
There is a problem with the
selected picture and it cannot
be played back on this
camera.
Pictures taken by other
cameras, taken in [D] or
previously edited or
corrected pictures cannot be
edited or fixed.
The battery/card
compartment cover is open.
The battery is empty.
The card was not read. Or,
the card is not formatted.
OK
There is an error in the
IN
internal memory.
OK
The camera is not connected
to the computer or printer
correctly.
There is no paper in the
printer.
The printer has run out of ink. Replace the ink cartridge in the printer.
Corrective action
This card cannot be used. Insert a new card.
The recorded image has been protected (read-
only) on a computer. Download the image to a
computer and cancel the read-only setting.
Insert a card or erase unwanted data.
Before erasing, back up the data of
important pictures using the card, or
download such pictures to a computer.
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
The internal memory or the card contains no
pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery/card compartment cover.
Charge the battery.
• Select [CLEAN CARD] and press o.
Remove the card and wipe the contact
area with a soft, dry cloth.
[YES] and press o.
• Select [FORMAT]
All data on the card is erased.
Select [MEMORY FORMAT]
press o. All data in the internal memory is
erased.
Disconnect the camera and connect it again
correctly.
Load some paper in the printer.
[YES] and