Olympus Stylus 500 Advanced Manual page 140

Troubleshooting
Possible cause
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures on
the card.
There is a problem with
the card.
The camera is
connected to a TV.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
The TV video signal
setting is incorrect.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
When the camera is connected to a computer or printer
(
Possible cause
The printer fails to connect.
PC was selected on the
monitor after connecting
10 the camera to the printer
with the USB cable.
The printer does not
support PictBridge.
The camera is not recognized by the computer.
The USB driver has not
been installed.
140
Corrective action
Set the mode dial to q or X, then press the
POWER switch to turn the camera on.
Press the QUICK VIEW button or set the
mode dial to q or X.
"NO PICTURE" is displayed on the monitor.
Record pictures.
See "Error codes".
The monitor does not function when the AV
cable is connected to the camera.
Display pictures with 9 and set [0] from
[MODE MENU] to [OFF] to cancel protection.
Set the video output signal according to the
region where used.
Set the TV to the video input mode.
Select [s] in the mode menu and adjust the
brightness.
Block the sunlight with your hand.
Corrective action
Remove the USB cable, and start again from
Step 1 of "Connecting the camera to a
printer".
Refer to the printer's instruction manual or
contact the manufacturer.
Install OLYMPUS Master.
Ref.
page
P.12
P.12, 14
–
P.134
P.84
P.88
P.85
P.84
P.97
–
Ref.
page
P.103
–
–