Juniper MX240 Quick Start Manual page 20

3d universal edge router

Hide thumbs Also See for MX240:

Table of Contents

MX240 3D Universal Edge Router Quick Start

Figure 11: Connect Power Cables

CAUTION:

Ensure that each power cable lug seats flush against the surface

of the terminal block as you are tightening the nuts. Ensure that each nut

is properly threaded onto the terminal stud. The nut should be able to spin

freely with your fingers when it is first placed onto the terminal stud.

Applying installation torque to the nut when improperly threaded may

result in damage to the terminal stud.

CAUTION:

The maximum torque rating of the terminal studs on the DC

power supply is 36 lb-in. (4.0 Nm). The terminal studs may be damaged

if excessive torque is applied. Use only a torque-controlled driver or socket

wrench to tighten nuts on the DC power supply terminal studs.

Replace the clear plastic cover over the terminal studs on the faceplate.

Repeat Step

through Step

Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect

the strap to an approved site ESD grounding point. See the instructions for your site.

Connect each DC power cable to the appropriate external DC power source.

NOTE:

For information about connecting to external DC power sources,

see the instructions for your site.

for the remaining power supplies.

Table of Contents