Olympus SP-510UZ Advanced Manual page 23

When [PRESET] is selected
PRESET WB
5
3
1
w
BACK SET OK
MENU
When [V] is selected
• With the [ONE TOUCH WB] screen displayed, point the camera at a sheet of white paper. Position
the paper so that it fills the screen, making sure there are no shadows.
• Press o. The new white balance is set.
ISO ......................................................................................
AUTO
50/100/200/
400/800/1600/
2500/4000
• If set to over [2500], [IMAGE QUALITY] is limited to below [2048 x 1536].
DRIVE
.......................................................................................................... Continuous shooting
o
Shoots 1 frame at a time when the shutter button is pressed.
j
Focus and exposure are locked at the first frame. The sequential shooting
speed varies depending on the setting of record mode.
i
Takes pictures at a faster speed than normal sequential shooting.
e
Adjusts the focus 1 frame at a time. The shooting speed is slower than for
normal sequential shooting.
BKT Takes pictures sequentially while changing the exposure for each frame.
Focus and white balance are locked at the first frame.
You can take a sequence of pictures at one time while holding down the shutter button. The camera
will take pictures in sequence until you release the shutter button.
• In high speed sequential shooting, flash will be limited to [$].
• Only [o] is available when [NOISE REDUCT.] is set to [ON].
• [j], [e] and [BKT] are not available when record mode is set to [RAW].
Press sr to select a white balance setting, then press o.
o
Sensitivity is automatically adjusted according to the conditions of the
subject.
A low value lowers the sensitivity for daylight shooting of clear, sharp
pictures. The higher the value, the better the camera's light sensitivity and
ability to shoot with a fast shutter speed and in low light conditions. However,
high sensitivity introduces noise into the resulting picture, which may give it
a grainy appearance.
1/4000 1/4000 F8.0 F8.0
P P
[ ]
[ IN IN ]
4 4
×
HQ 3072 HQ 3072 2304 2304
Changing the ISO sensitivity
23
EN