Olympus FE-330 Instruction Manual page 45

Monitor indication
The card has no available
q
memory and cannot store
CARD FULL
any new data.
There are no pictures in the
L
internal memory or on the
NO PICTURE
card.
There is a problem with the
r
selected picture and it
cannot be played back on
PICTURE ERROR
this camera.
r Pictures taken by other
THE IMAGE cameras, or previously
CANNOT BE edited or corrected pictures
EDITED cannot be edited or fixed.
The battery/card
compartment cover is open.
CARD-COVER
OPEN
g The battery is empty.
BATTERY EMPTY
The card is not being
CARD SETUP
recognized by the camera.
Or, the card is not formatted.
CLEAN CARD
FORMAT
SET OK
There is an error in the
MEMORY SETUP
IN
internal memory.
POWER OFF
MEMORY FORMAT
SET OK
The camera is not
connected to the computer
NO CONNECTION
or the printer correctly.
There is no paper in the
printer.
NO PAPER
The printer has run out of
ink.
NO INK
The paper is jammed.
JAMMED
The printer's paper tray has
been removed or the printer
SETTINGS
has been operated while
CHANGED
changing settings on the
camera.
There is a problem with the
printer and/or camera.
PRINT ERROR
Pictures recorded on other
r
cameras may not be printed
CANNOT PRINT
on this camera.
Possible cause Corrective action
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
The internal memory or the card contains
no pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery/card compartment cover.
Charge the battery.
• Select [CLEAN CARD], and press  .
Remove the card and wipe the contact
area with a soft, dry cloth.
• Select [FORMAT] [YES] and press
 . All data on the card is erased.
Select [MEMORY FORMAT]
press  . All data in the internal memory is
erased.
Disconnect the camera and connect it
again correctly.
Load some paper into the printer.
Replace the ink cartridge in the printer.
Remove the jammed paper.
Do not operate the printer while changing
settings on the camera.
Turn off the camera and printer. Check the
printer and remedy any problems before
turning the power on again.
Use a computer to print.
[YES] and
45
EN