Stihl 015 Instruction Manual / Owners Manual page 26

24
Starting throttle position on 015, 015 L, 015 LE
4. Set throttle trigger to starting throttle position: Depress
at first safety throttle lock (4), then throttle trigger (5)
and starting throttle lock (6). Next release throttle
trigger (5) and then starting throttle lock (6).
Important! Take care that the starting throttle lock is
different positioned.
5. Hold the front handle bar with your left hand, for type AV
also put your right foot through rear handle.
6. Pull starter grip (9) slowly with your right hand until you
feel the starter engage. Then make a short, quick pull.
Do not allow the grip to snap back, but guide the starter
rope slowly back to permit the rope to rewind properly.
Crank until the engine fires. Then open choke (choke
lever away from "ChOke") if the saw is cold and pull
again. Failure to follow this procedure may result in
injury to hand or fingers and may damage the starting
mechanism.
Top: Starting throttle position on 015 AV, 015 AVE
Center: Correct handling of the chain saw
Bottom: Starting
_ _ _ _ _ _ 7