Returning To A Pre-Marked Position - Canon MD255 Instruction Manual

Video
Special Playback Modes
To enter most special playback modes you need to operate the buttons on the
wireless controller (
Special playback mode
Fast playback
Reverse playback
1 frame reverse/advance
Frame-by-frame playback
Slow playback
Double speed playback
Return to normal playback
1
During some special playback modes you may notice some anomalies (blocky video
artifacts, banding, etc.) in the playback picture.

Returning to a Pre-marked Position

If you wish to return to a particular
scene later, mark the point with the zero
set memory and the tape will stop at
that point when you rewind/fast forward
the tape. This function is operated with
the wireless controller.
1
While recording or during
playback, press
at the point you wish to return to
later.
• The time code changes to
"0:00:00
Downloaded From VideoCamera-Manual.com Manuals
34
1
12). There is no sound during the special playback modes.
Initial mode
Normal playback
Normal playback
Playback pause
Playback pause
Normal or reverse
playback
Normal or reverse
playback
Special playback mode
(
ZERO SET MEMORY
".
Operation on the camcorder
or on the wireless controller
: Push the joystick (
( ) toward
: Press and hold
: Press
: Press
: Press and hold
: Press
: Press
: Push the joystick (
: Press
• Press
cancel the memory.
2
If you marked the zero memory
while recording, set the
camcorder to
you marked the zero memory
during playback, press
3
Press
• If the tape counter shows a
negative number, press
20)
instead.
• appears and the camcorder
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark,
correct time code will be displayed
again.
) toward
and hold it down.
REW FF
or
or
or
SLOW
) toward
PLAY
again to
ZERO SET MEMORY
mode. If
STOP
to locate the zero mark.
disappears and the
or
.
/
.