System Time - D-Link DIR-816L User Manual

DIR-816L Wireless AC750 Dual Band Router & Access Point
with 3G/CDMA/LTE Support and USB Port
User Manual

System Time

On the System / System time page, you can manually set the time and date of the router or
configure automatic synchronization of the system time with a time server on the Internet.
To set the system time manually, select the Manual value from the Mode drop-down list and set
the time and date in the fields displayed. Then click the Apply button.
To enable automatic synchronization with a time server, follow the next steps:
1. Select the NTP value from the Mode drop-down list.
2. Select your time zone from the drop-down list. To set the time zone in accordance with the
settings of your operating system, click the Determine timezone button in the bottom
right corner of the page.
3. Specify the needed NTP server in the NTP servers field or leave the server specified by
default.
4. Click the Apply button.
In some cases NTP servers addresses are provided by your ISP. In this case, you need to select the
Get NTP server addresses using DHCP checkbox. Contact your ISP to clarify if this
checkbox needs to be enabled. If the Get NTP server addresses using DHCP checkbox is
selected, the NTP servers field is not available.
After clicking the Apply button, the date and time set for the router will be displayed in the
System date and System time fields.
Figure 225. The System / System time page.
Page 292 of 304
Configuring Device (Access Point Mode)