Dolmar MS-4215 Original Instruction Manual page 19

4. Wind the lines up firmly to the direction slown by left-hand (LH) arrow on the
flange. Do not cross the lines.
5. Wind all but about 100 mm (3-15/16") of the cords, leaving the end temporarily
hooked through a notch on the side of the spool.
6. Put tab knob onto the housing hub, positioning it can freely move up and down
against spring tension. Put the spool into the housing, aligning the teeth on
spool and tap knob alternately like gears.
7. Put in the cutting lines through the slot of eyelets.
8. Put the cover onto the housing, aligning the tabs on cover and the windows
on housing. Make sure the cover is secured exactly to the housing. Outer
edge of cover locking tab and outer surface of the housing should be on same
circumference.
To "LH" direction
19
Wind tightly
100 mm from
notches
Tab knob's teeth
Spool's teeth
Cover locking tab
Housing window
Outer edge Outer
of cover surface of
locking tab housing