Asus P5SD1-FM2 User Manual page 39

4 .
ASUS
This Manual: http://www.manuallib.com/file/2595652
Serial ATA connectors
(7-pin SATA1 [blue], SATA2 [blue], SATA3 [black],
SATA4 [black])
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
These connectors are set to Standard IDE configuration by default. In
Standard IDE mode, you can connect Serial ATA boot/data hard disk
drives to these connectors.
P5SD1-FM2 SATA connectors
Important notes on Serial ATA
• The Serial ATA RAID feature (RAID 0, RAID 1) is available only if you
are using Windows
• Install the Windows
• Use only a maximum of two ports for each RAID 0 or RAID 1 set.
• Plug your Serial ATA boot disk on the master port (SATA1 and
SATA2) to support S3 function. Refer to the table below for details.
Serial ATA Master/Slave connectors
C o n n e c t o r
SATA1 , SATA2
SATA3, SATA4
P5SD1-FM2
SATA1
SATA3
® XP.
® XP Service Pack 1 before using Serial ATA.
C o l o r S e t t i n g
Blue Master
Black Slave
SATA2
SATA4
U s e
Boot Disk
Data Disk
1 - 2 9