Connecting The Appliance; Switching On The Appliance - Bosch KGN Series Operating Instructions Manual

Connecting the
appliance
After installing the appliance, wait at
least ½ hour until the appliance starts
up. During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to 220-240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 to 16 A fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to
electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment,
power supplies on ships).
Downloaded from Fridge-Manual.com Manuals
Switching on the
appliance
Fig. 1
Switch on the appliance with On/Off
button 2.
Fig. 2
A warning signal sounds, AL" flashes
on the freezer compartment display.
Press the alarm off" button. The warning
signal switches off.
Display AL" goes out when the appliance
has reached the set temperature.
The factory has recommended and set
the following temperatures:
Refrigerator compartment:
Freezer compartment:
Operating tips
S The fully automatic Nofrost system
keeps the freezer compartment and
refrigerator compartment free of ice.
Defrosting is no required.
S The sides of the housing are sometimes
heated slightly. This prevents conden
sation in the area of the door seal.
S If you cannot open the freezer
compartment door immediately after
closing it, wait 2 3 minutes until the
partial vacuum has equalised.
en
+4 °C
-18 °C
25