Viewing Images - Olympus Camedia C-2500L Instructions Manual

6
7
Self-timer signal
5m (16.5ft.)

Viewing Images

You can display images on the LCD monitor at any time. Not only can you view images one frame at a time, it is also possible to
display them as an index or slide show.
2
MEMO
6
Determine the composition, and cover the viewfinder with the
lens cap holder to block incoming light from the view finder.
7
Point the remote control at the camera and press the transmit
button. Remember to be within the remote control's transmis-
sion range.(Read the remote control instructions)
The camera will emit a tone when it receives the signal. The self-
timer signal will blink for 2 seconds and the shutter will click.
NOTE
• Sequence mode cannot be operated by remote control.
• The camera cannot be operated by remote control if the remote con-
trol's batteries are dead.
Battery life is about 5 years, though this will depend on conditions of
use and the surrounding environment.
• Keep the remote control out of the reach of infants and small chil-
dren. If accidentally swallowed, see a physician immediately.
• Never disassemble, heat or dispose of the remote control by inciner-
ation. All of these acts are dangerous.
• The available distance from the remote control decreases where
exposure to strong light such as direct sunlight occurs. Do not expose
the photoreceptor in strong light.
• Remote control may not be used under the strong light of a fluores-
cent lamp.
MEMO
• Pictures sometimes cannot be taken by remote control if the subject
15¡
is backlighted or cannot be brought into focus with the autofocus fea-
ture. For more information, see "Hard-to-(Auto) Focus Subjects"
15¡
(P.17).
• Remote control mode will not be cancelled after taking a picture. You
can continue shooting with the remote control.
• After taking pictures, cancel the remote control mode.
Frame-by-Frame Viewing
Images are displayed on the LCD monitor one frame at a time as follows.
1
Set the mode dial to
1
2
Press the [SM/CF] button and select the card which contains the
image you want to view.
The first image on the selected card will appear on the LCD monitor.
3
Press the jog dial to display images to view.
Displays the previous image.
Displays the next image.
Forwards by ten frames.
3
Backwards by ten frames.
Caution
• Do not touch the surface of LCD monitor; this can leave a blur on
the monitor. Pushing hard may break the monitor.
• Power to the camera is shut OFF automatically if the camera is not
operated for an interval. This is referred to as "sleeping". Pressing the
ON/OFF button turns the camera back ON.
• Images can be displayed frame-by-frame automatically. This is ref-
fered to as "slide shows" . See page 54.
• When the file is DCF 98 format, a 3-digit directory No. and a 4-digit
file no. are displayed on the control panal.
.
E
E-25