Olympus Stylus 1010 Instruction Manual page 57

When you get an error message on the camera
Monitor indication
There is a problem with the
q
card.
CARD ERROR
Writing to the card is
q
prohibited.
WRITE PROTECT
The internal memory has no
>
available memory and
cannot store any new data.
MEMORY FULL
The card has no available
q
memory and cannot store
any new data.
CARD FULL
There are no pictures in the
L
internal memory or on the
card.
NO PICTURE
There is a problem with the
r
selected picture and it
cannot be played back on
PICTURE ERROR
this camera.
Pictures taken by other
r
cameras take in [D], or
previously edited or
THE IMAGE
corrected pictures cannot be
CANNOT BE
edited or fixed.
EDITED
The battery/card
compartment cover is open.
CARD-COVER
OPEN
The battery is empty.
g
BATTERY EMPTY
The card was not read. Or,
CARD SETUP
the card is not formatted.
CLEAN CARD CLEAN CARD
FORMAT
OK
SET
There is an error in the
MEMORY SETUP IN
internal memory.
POWER OFF POWER OFF
MEMORY FORMAT
OK
SET
The camera is not
connected to the computer
NO CONNECTION or printer correctly.
There is no paper in the
printer.
NO PAPER
Possible cause Corrective action
This card cannot be used. Insert a new
card.
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
Insert a card or erase unwanted data.
Before erasing, backup the data of
important pictures using the card, or
download such pictures to a computer.
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
The internal memory or the card contains
no pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery/card compartment cover.
Charge the battery.
• Select [CLEAN CARD], and press e.
Remove the card and wipe the contact
area with a soft dry cloth.
• Select [FORMAT] [YES] and press
e. All data on the card is erased.
Select [MEMORY FORMAT]
press e. All data in the internal memory
is erased.
Disconnect the camera and connect it
again correctly.
Load some paper in the printer.
[YES] and
57
EN