RIDGID r4510 Operator's Manual page 36

AdjuSTmeNTS
TO SeT The bevel INdIcATOR ANd bevel
STOpS AT 0˚ ANd 45˚
See Figures 52 - 55.
The angle settings of the saw have been set at the factory
and, unless damaged in shipping, should not require set-
ting during assembly. After extensive use, it may need to
be checked.
To check for squareness, 0˚ position:
 Unplug the saw.
 Raise the blade to a 3 in. depth of cut.
 Release the bevel locking lever.
 Push the bevel adjusting handwheel to the left as far as
possible.
 Lock the bevel locking lever.
 Place the combination square against blade. Make sure
square is not touching the tip of one of the saw teeth.
If blade is square to the table:
 Check bevel indicator.
 If indicator is not pointing to the 0º mark on the bevel
scale, loosen the indicator adjusting screw and adjust
indicator.
 Retighten screw.
If blade is not 0º to the table:
 Loosen 0º stop screw until it is even with the top of the
saw table using a hex key.
 Release the bevel locking lever and position the bevel
adjusting handwheel until blade is 0º to the table. Lock
the bevel locking lever.
 Screw the 0º stop screw until the saw blade starts to move.
Check again for squareness and readjust if needed.
 Check bevel indicator.
 If indicator is not pointing to the 0º mark on the bevel
scale, loosen the indicator adjusting screw and adjust
indicator.
 Retighten screw.
To check for squareness, 45˚ position:
 Release the bevel locking lever.
 Push the bevel adjusting handwheel to the right as far as
possible.
 Lock the bevel locking lever.
 Place the combination square against blade. Make sure
square is not touching the tip of one of the saw teeth.
If blade is square to the table:
 Check bevel indicator.
 If indicator is not pointing to the 45º mark on the bevel
scale, loosen the indicator adjusting screw and adjust
indicator.
 Retighten screws.
blade at 0˚ position
BEvEL LoCkiNg
LEvER
iNDiCAtoR
ADjuStiNg SCREW
blade at 45˚ position
0˚ stop
SCREW
36
BEvEL ADjuStiNg
HANDWHEEL
Fig. 52
Fig. 53
Fig. 54