RIDGID r4510 Operator's Manual page 15

ASSEMblY
TO OPEN THE lEG STAND
See Figures 7 - 9.
 Grasp the grips on the saw table and stand it upright as
shown below.
 Step on the release lever and pull the grips toward you
at the same time.
 Once the leg stand is released from the release lever,
ease the leg stand toward the floor by pushing the grips
toward the floor.
 With your hands on the grips, push the leg stand towards
the ground until the table saw is in an open position.
NOTE: The release lever will close over the center brace
locking the leg stand in an open position.
ReleaSe leVeR
GRIPS
leG STaND
Fig. 7
15
Fig. 8
CeNTeR
bRaCe
ReleaSe
leVeR
Fig. 9