Security Features; Ethernet Ports; Power Source Options; Factory Reset Button - Cisco MERAKI MR34 Installation Manual

Security Features

The MR34 features multiple options for physically securing the access point after installation:
1. Security screw – The accessory kit includes screws that can be used to secure the access point to the mount
cradle. Engaging the security screw prevents accidental dislodging and theft.
2. Kensington lock – The access point contains a hard point that allows it to be secured to any nearby permanent
structure using a standard Kensington lock.

Ethernet Ports

The MR34 features a Gigabit Ethernet RJ45 port that accepts 802.3at and 802.3af power (labeled "Eth0, PoE"). This
port should be used for uplink to your WAN connection.

Power Source Options

The MR34 access point can be powered using either the Meraki AC Adapter, PoE Injector (both sold separately), or a
third-party PoE switch.

Factory Reset Button

If the button is pressed and held for at least five seconds and then released, the MR34 will reboot and be restored to its
original factory settings by deleting all configuration information stored on the unit.

LED Indicators and Run Dark Mode

Your MR34 is equipped with a multi-color LED light on the front of the unit to convey information about system
functionality and performance:
• Orange - AP is booting (permanent Orange suggests hardware issue)
• Rainbow - AP is initializing/scanning
• Blinking Blue - AP is upgrading
• Green - AP in Gateway mode with no clients
• Blue - AP in Gateway mode with clients
4