Installing The Mounting Frame, Glass And Coil Carrier - Garland GI-MO/DU 7000 Installation, Operation And Maintenance Manual

Section 2

INSTALLING THE MOUNTING FRAME, GLASS AND COIL CARRIER

IIMPORTANT: Factory supplied frames are intended for installations on counter-tops 1.5mm to 3mm thick [16- to
10-gauge].
NOTE: For counter-top thickness of 20mm to 30mm [1"] or stone countertop installation, please contact Factory for
assistance.
Partition
When installing two coil carrier sheets on the same frame, you must install a non-magnetic steel partition plate in
between them. This plate isolates the magnetic fields and prevents the fields from interfering each other.
Order of Installation
1. Mounting frame
2. Silicone gaskets
3. Glass-top
4. Coil carrier sheet
NOTE: Coil and sensor assembly will be compressed by about 5mm after installation.
3
2
1
4
Part Number 4532415 Rev 5 12/15
55mm
Installation
50mm
2mm
+/-
33