Table of Contents
Advertisement
Installation Precautions
Environment
Other Precautions
OPERATION GUIDE
CAUTION:
or not level. Such locations may cause the printer to fall. This type of
situation presents a danger of personal injury or damage to the printer.
Avoid locations with humidity or dust and dirt. If dust or dirt becomes
attached to the power plug, clean the plug to avoid the danger of fire or
electrical shock.
Avoid locations near radiators, heaters, or other heat sources, or locations
near flammable items, to avoid the danger of fire.
To keep the printer cool and facilitate changing of parts and maintenance,
allow access space as shown below. Leave adequate space, especially
around the side cover, to allow air to be properly ventilated from the printer.
Left: 300 mm
(11-13/16 inches)
•
Adverse environmental conditions may affect the safe operation and
performance of the printer. Install in an air-conditioned room
(recommended room temperature: around 23 °C, humidity: around
60% RH) and avoid the following locations when selecting a site for
the printer.
-
Avoid locations near a window or with exposure to direct sunlight.
-
Avoid locations with vibrations.
-
Avoid locations with drastic temperature fluctuations.
-
Avoid locations with direct exposure to hot or cold air.
-
Avoid poorly ventilated locations.
•
If the flooring is of a soft material, it may be damaged by the casters
when this product is moved after installation.
Avoid placing the printer on or in locations which are unstable
Top: 750 mm
(29-1/2 inches)
Right: 250 mm
Rear: 200 mm
(10 inches)
(7-7/8 inches)
([400 mm (15-3/4 inches)
when the optional face-up
output tray is installed]
Front: 600 mm
(23-5/8 inches)
xiii
Advertisement
Table of Contents
