Raymarine VCM100 Installation Instructions Manual page 36

3. Using a 3 mm drill bit, drill the 4 holes, as indicated on the
mounting template.
Check that the holes have been drilled in the correct position.
4. Using an 11 mm drill bit, drill through the 4 holes.
5. Remove the mounting template.
6. Ensure the lifting eyes are fitted to the pedestal. To fit a lifting
eye, remove the securing bolt, place the lifting eye in position,
and then secure the lifting eye with the bolt, to 7 Nm (5.2 lb ft)
torque.
36
7. The pedestal unit has a cap fitted over the open array mounting
shaft to protect the protruding coaxial pin. This cap must be left
in place until the open array antenna is fitted to the pedestal.
8. Grease the 4 metal studs with the supplied Denso paste.
D10491-2
18 mm
9. Insert the studs no more than 18 mm into the holes in the
pedestal base, and hand-tighten. 4 spare nuts are provided
HD and SuperHD Digital Open Array Installation instructions
D11781-1