Measuring And Programming Water Hardness - Saeco INCANTO EXECUTIVE HD9712 User Manual

ENGLISH
16
9 After dispensing water, remove and empty the container.
10
Repeat the steps from 5 to 9 until the water tank is empty, then con-
tinue with step 11.
11 At the end of this operation, fi ll the water tank again up to the MAX
level. Now the machine is ready to brew coff ee.
Note:
When you have not used the machine for two or more weeks, the machine
will perform an automatic rinse/self-cleaning cycle after you turn it on. Fol-
lowing this, you need to perform a manual rinse cycle as described above.
The automatic rinse/self-cleaning cycle is also initiated automatically when
starting up the machine (with a cold boiler), when the machine is preparing
to go into stand-by mode or after pressing the " " button to turn off the
machine (after a coff ee has been brewed).

MEASURING AND PROGRAMMING WATER HARDNESS

Water hardness measuring is very important in order to defi ne the descal-
ing frequency and to install the "INTENZA+" water fi lter (for more details on
the water fi lter, see next chapter).
To measure water hardness, follow the steps below.
1
Immerse the water hardness test strip supplied with the machine in
water for 1 second.
Note:
The test strip can only be used for one single measurement.