Table of Contents
Advertisement
1.2.11
Notes on Installing Devices in the Rack
CAUTION!
l
l
1.2.12
Environmental Protection
Environmentally-friendly product design and development
This product has been designed in accordance with the Fujitsu standard for "environmentally
friendly product design and development". This means that key factors such as durability,
selection and labeling of materials, emissions, packaging, ease of dismantling and recycling
have been taken into account.
ETERNUS CS800
Never lift the devices into the rack using the handles on the front panel.
For safety reasons, not more than one unit may be unlocked or pulled out of
the rack at a time, otherwise the rack may tip over.
This is illustrated by the following pictogram:
If necessary, have other people help you mount the individual
l
components in the rack because of the weight involved.
When connecting and disconnecting cables, observe the relevant
l
instructions in the "Important Information" chapter of the technical
manual for the corresponding rack. The technical manual is supplied with
the corresponding rack.
Route cables in such a way that they do not form a potential hazard
l
(make sure no one can trip over them) and that they cannot be damaged.
The rack must be connected to the power supply by an authorized
l
electrician approved by the local utility company.
If the rack model is integrated into an installation that draws power from
l
an industrial power supply network with an IEC309 type connector, the
power supply's fuse protection must comply with the requirements for
non-industrial power supply networks for the type A connector.
An ETERNUS CS800 configuration can carry a leakage current > 3.5
l
mA. Therefore, a ground connection must be established before
connecting to the mains.
1 Introduction
23
Advertisement
Table of Contents
