Advertisement
b. SFP: If fiber access is available, insert a fiber optic SFP module and
connect the fiber optic cable for Internet access. (See
Installation and Removal
c. GbE: If you already have a broadband router or modem, use an Ethernet
cable to connect the GbE port to it for Internet access.
Your Device does not use Fiber (SFP) and broadband (GbE)
connections at the same time.
5. ETHERNET LAN: Use an Ethernet cable to connect a computer to an
Ethernet port for initial configuration and/or Internet access.
6. USB: Do one of the following USB connections:
a. Connect a USB (version 2.0 or lower) memory stick or a USB hard drive
for file sharing. The Device automatically detects the USB device.
b. Connect a 3G adapter to access the Internet wirelessly via a 3G network.
7. 12V DC: Use the provided power adaptor to connect the 12V DC socket on
the Device's rear panel to an appropriate power source. Push the Device's
ON/OFF button to the ON position. Make sure the power at the outlet is on.
Look at the lights on the front panel.
• The PWR light blinks while your Device starts up and then stays on once it
is ready.
• The DSL light is green when your Device has an ADSL connection. It is
orange when you have a VDSL connection. The DSL2 light comes on
when using DSL bonding
• The INET light turns on when the gateway is able to access the Internet.
• The USB light turns on when your Device detects a connected USB device
and blinks when there is traffic.
• The SFP light turns on after your Device has a fiber connection and blinks
when there is traffic.
1. Applies to the SBG3600-N000.
on page
8
for more information on SFP module.)
1
.
7
Transceiver
Advertisement
