Epson Stylus Pro 4000 Printer Manual page 95

Tip: You can store
partially used ink
cartridges for up to
6 months.
Maintaining and Transporting the Printer
9. When the uni-directional alignment is finished, press the
you see
BI-D BLACK
bi-directional black alignment process, which is also completely
automatic and takes about 7 minutes.
10. When the bi-directional black alignment is finished, press the
until you see
BI-D ALL
the alignment process. Again, this process is completely automatic and
takes about 7 minutes.
11. When done, press the
If you want to verify or fine-tune the automatic alignment process, you can
perform a manual head alignment. See your electronic Reference Guide for
instructions.
Replacing Ink Cartridges
Before you begin a large print job, you should check your ink levels. If one of
your cartridges is low, you can replace it before you start. Or you can wait
until the ink runs out, replace the cartridge, and then continue the job
without any loss of print quality.
4-79
. Then press the
Menu
. Then press the
Menu
Pause button to exit the head alignment mode.
| 79
button until
button again to start the
button
button again to start