Table of Contents
Advertisement
Installation Guide
9
2.4.2 Grounding Hardware and Connections
The grounding cable for an AP 7181 must be a #8 gauge (10 mm) wire cross section and use a ring lug that fits the
Grounding Hardware and Connections
M5 grounding screw on the bottom of the unit (see
).
The grounding screw is shown below in green:
When connecting the grounding cable to the unit, tighten the grounding screw from 21.9 - 29.2 inch pounds (lbf-in).
Access points mounted on a metallic pole should be grounded as shown in the following figure:
Hide quick links:
Advertisement
Table of Contents
