Hardware Installation; Precautions - Motorola AP 7181 Installation Manual

6

2 Hardware Installation

An AP 7181 Access Point installation includes mounting the Access Point, connecting the Access Point to the
network, and applying power. Installation procedures vary for different environments.

2.1 Precautions

Before installing an AP 7181 Access Point, verify the following:
• Become familiar with grounding requirements
• The grounding cable for an AP 7181 must be a #8 gauge (10 mm) wire cross section and use a ring lug
that will fit the M5 grounding screw on the bottom of the unit
• Verify the environment has a continuous temperature range between -40° C to 55° C
AP 7181 Access Points must be installed by trained professionals familiar with RF planning and regulatory limits
defined by the regulatory bodies of the country where the devices are being deployed. All common precautions for
grounding and Electrostatic Discharge (ESD) protection should be observed during deployment and installation. AP
7181 access Points are designed to be installed outdoors and must be installed such that no harmful interference
results from device operation.
CAUTION
WARNING!
• Installations must be performed by professionals who are properly trained and certified,
• Avoid contact with overhead power lines,
• Take precautions to avoid injury from falling tools and equipment. Crews should wear hard hats in and
around the installation work site.
• Be aware of vehicular traffic in and around the installation work site.
• Do not hold any component containing a radio such that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
• Do not operate a portable transmitter near unshielded blasting caps or in an environment where
explosives are present unless the transmitter is especially certified for such use.
All device wiring must comply with the National Electric code (NEC) or regulations
and procedures defined by the regulatory bodies of the country or region where the
devices are being deployed. All local building and structure codes must be
observed.
Strictly observe the following safety precautions during the AP 7181 installation
procedure.
AP 7181 Access Point