Unpacking And Installation; Parts Included - Toshiba MR-2018 Service Manual

[2] UNPACKING AND INSTALLATION

1. MR-2018/2019 Installation
The installing procedures below are described for the MR-2018.
The installing procedures for the MR-2019 are the same as below.
•

Parts included

MR-2018 Unit (RADF Unit)
MR-2018 Unit (ADF Unit)
Right glass holder: 1 pc.
(For Europe only)
Turn the main switch to the "OFF" position and remove the power
plug from the outlet.
1) Remove the document cover.
Remove the document cover from the copier.
Screw (M3 x 8): 1 pc.
Screw (M3 x 6): 1 pc.
Installation manual: 1 sheet
"OFF"
MR-2019/2018/MY-1034 UNPACKING AND INSTALLATION 2 - 1
2) Remove the rear cabinet.
Remove the three screws and then remove the rear cabinet.
3) Replace the right glass holder (For Europe only).
<1> Remove the two screws, and remove the right exterior
OC.
<2> Attach the right glass holder, and fix it with the two screws
which was removed in the above procedure.