Table of Contents
Advertisement
chimney. On the other hand, a black greasy deposit that is difficult to remove is a result of wet and green wood and
too slow a burning rate. This heavy deposit is building up in the chimney as well.
WARNING: ONLY USE MATERIALS AND COMPONENTS SUPPLIED BY MANUFACTURER WHEN DOING
MAINTENANCE OR REPLACEMENTS.
4. DOOR GASKETS - The gasket used on this unit (3/4" high density fiberglass rope) requires only light pressure to
seal. This will prolong seal life. It is important that the door seal be maintained in good condition. Periodically
inspect seals and replace if necessary. Follow instructions included in the WODC.NEODGKIT obtainable from your
nearest Pacific Energy Dealer.
5. DOOR GLASS - Do not slam loading door or otherwise impact glass. When closing door, make sure that no logs
protrude to impact the glass. If the glass gets cracked or broken, it must be replaced before using the stove.
Replacement glass can be obtained from your dealer. Use 16-1/2"(419mm) x 10-1/2"(267mm) x 5 mm. Ceramic
glass only. Do not substitute with any other type.
To remove broken glass, remove the door gasket and then undo the eight screws securing the gasket guides
and glass retainers. Remove all particles of glass . Be careful as they are very sharp. Clean out gasket channels.
Install new glass complete with gasket. Reinstall glass retainers and gasket guides, tighten screws very carefully.
DO NOT overtighten. Then install new door gasket as per instructions provided with the door gasket kit.
CAUTION:
•
Do not clean glass when hot
•
Do not use abrasive cleaners on glass
6. The area where boost combustion air enters the firebox must be kept clear of excessive ash buildup which will block
air flow. This area is at the front, center of the firebox.
7. Do not store wood within stove installation clearances, or within the space required for fuel loading and ash removal.
Keep the area around the stove clean and free of loose combustibles, furniture, newspapers, etc.
8. Establish a routine for the fuel, wood burning and firing technique. Check daily for creosote buildup until experience
shows how often you need to clean to be safe.
9. Be aware that the hotter the fire, the less creosote is deposited. Weekly cleaning may be necessary in mild weather,
even though monthly cleaning is usually enough in the coldest months when burning rates are higher.
Instruct all members of your family on the safe operation of the stove. Ensure they have enough knowledge of the entire
system if they are expected to operate it. Stress the section on chimney fires and the importance of following the steps
outlined "In Case of Chimney Fire".
Baffle Removal
Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible should you
remove baffle assembly. CAUTION: Ceramic blanket insulation is located on top of baffle. Do not use a vacuum in this
area.
DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.
Remove the retaining pin at the back of the firebox, just under the baffle. Lift baffle up on one side and remove the cor-
responding brick rail by lifting up and off the mounting pins. Lift the entire Baffle up and pull forward to disconnect from
the supply tube. Tilt baffle sideways to drop down and remove from firebox. Re-install baffle assembly in reverse order.
WARNING Sweep/Clean chimney with baffle installed or be sure to plug the top of the baffle
tube in the back of the firebox before sweeping or cleaning. Failure to prevent ash or soot
from falling into the baffle tube will cause incorrect operation and will lead to premature burn
out of the tube or baffle.
120416-24_NEO 1.2 EU-En
9
Operator Instructions
5055.600EU-A
Advertisement
Table of Contents
