Scag Power Equipment STWC Operator's Manual page 24

TROUBLESHOOTING (CONT'D)
CONDITION
Uneven Cut on Flat
Ground - Wavy
High-Low
Appearance,
Scalloped Cut, or
Rough Contour
Width of Deck
SGB020
Uneven Cut on
Uneven Ground -
Wavy Appearance,
High-Low Scalloped
Cut, or Rough Contour
Width of Deck
Sloping Ridge Across
Width of Cutting Path
Width of Deck
SGB023
CAUSE
Lift worn from blade
Blade upside down
Deck plugged, grass accumulation
Too much blade angle (deck pitch)
Deck mounted improperly
Bent spindle area
Dull blade
Uneven ground
SGB021
Tire pressures not equal
Wheels uneven
Deck mounted incorrectly
Deck not level side-to side
Replace blade
Mount with cutting edge toward
ground
Clean underside of deck
Adjust pitch and level
See your authorized SCAG dealer
See your authorized SCAG dealer
Sharpen blade
May need to reduce ground speed,
raise cutting height, and/or change
direction of cut
Check and adjust tire pressure
Check and adjust tire pressure
See your authorized SCAG dealer
Check for level and correct
20
Section 5
CURE