Setup & Connections - Numark CDN 36 Owner's Manual

SETUP & CONNECTIONS
Typical connection with a mixer is illustrated below.
1. Mount the units in your console or rack with 19" EIA rails.
2. The transport should be mounted not to exceed an angle of 15 degrees.
3. Your CD player can be affected by excess vibration so mount the units in a
secure environment if possible.
4. Connect the supplied Control Cables between the CD Remote and CD Transport
unit. Note: Be careful to attach the marked connection jacks together, (yellow
–yellow and black-black)
5. Connect the line output connections using the supplied audio cables from the
CD Player to the line inputs of your mixer.
6. Connect Fader start cable. Attach your CD play to a similarly equipped DJ
mixer. (This connection can also be used with a remote switch)
7. Connect IEC power cord to appropriate power source.
LINE VOLTAGE SELECTION
1) The desired voltage may be set with the VOLTAGE SELECTOR switch on the rear panel of the unit.
2) Do not move the VOLTAGE SELECTOR switch with excessive force as this may cause damage.
3) If the VOLTAGE SELECTOR switch does not move smoothly contact a qualified serviceman.
DIGITAL OUTPUTS
This CD player is specially equipped with digital outputs. The format is type 2, form 1, also known as
S/PDIF (Sony/Phillips Digital Interface Format). When the digital output is used the variable pitch slider
and pitch bend buttons or pitch wheel should not be used.
Note: If digital information is allowed to change in pitch, other devices may not read the digital output
properly.
©2002 Numark Industries
- The Leader in DJ Technology
- 5 -
CDN 36
115V
230V
http://www.numark.com