Dell PowerEdge R630 Owner's Manual page 173

Steps
1. Push the VGA module into the chassis and align the threaded screw hole on the VGA module with
the screw hole on the chassis.
2. Replace the screw (at the bottom of the chassis) that secures the VGA module to the chassis.
3. Replace the control panel.
4. Connect the VGA module cable to the VGA module.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure
that the locking tab on the connector is released before removal and insertion. The locking
tab must be engaged after insertion.
5. Connect the display module cables to the control panel board.
Figure 96. Installing the VGA module
1. screw
3. VGA module
Next steps
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Installing the control panel–10 hard drive system and 24 hard drive system
Installing the control panel–eight hard drive system
After working inside your system
2. VGA module cable
4. control panel
173