Troubleshooting - Bosch Vision 300 Operating, Care And Installation Instructions Manual

Troubleshooting

,
WARNING
Problem
Dryer does not start. Dryer does not start.
Start/Pause" indicator light does not Start/Pause" indicator light does not
illuminate. illuminate. illuminate.
Laundry is wet after drying.
Cycle has been interrupted. A warning
signal is emitted and the display shows
CLn".
Cycle has been interrupted. A warning
signal is emitted and the display shows
E:12". E:12".
Degree of drying has not been reached
or the drying time is too long. or the drying time is too long.
Display may indicate E:03". Display may indicate E:03".
1.
2.
3.
4.
Possible cause
Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
A fuse or circuit breaker has tripped.
Start/Pause" button not pressed.
No program selected.
Door not closed.
Ambient temperature below 41°F (5 °C.)
The shut off valve is closed.
Lint filter dirty.
Exhaust air duct is blocked or too long.
Fault in program sequence or malfunction.
The room/cabinet is not adequately ventilated.
Moisture sensor dirty.
Exhaust air duct is blocked or is too long.
Lint filter dirty.
Laundry was too wet.
Unsuitable program selected.
Maximum drying time was exceeded.
Motor limit temperature was exceeded.
Degree of dryness not correctly set.
Remedial action
Replace fuse or reset circuit breaker.
Press Start/Pause" button.
Select program.
Close door.
Increase room temperature.
Open the shut off valve.
Clean the lint filter as described on page 28.
Switch the dryer off/switch on again. If this does not
clear the error code, call Customer Service (pg. 33).
Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 17.
Switch the dryer off/switch on again.
Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.
Provide an adequate supply of fresh air.
Switch off/switch on again.
Clean moisture sensor as described on page 30.
Switch the dryer off/switch on again.
Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 17.
Switch the dryer off/switch on again.
Clean filter as described on page 28.
Switch the dryer off/switch on again.
Spin laundry at higher speed in the washing
machine. Switch the dryer off/switch on again.
Select program with aid of the program selection
table (see page 23). Switch the dryer off/switch on
again.
Clean lint filter (see page 28).
Check exhaust air duct.
Spin laundry at a higher speed in your washer.
Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
800 Series, Change settings for degree of dryness,
see page 26.
31