View Parameters - Nortel CTA 500dm Installation Manual

38 AT commands

View Parameters

Result Codes
Set Local Echo
Result Codes
CTA 500 dm On Line Guide
The View Parameters Command
instructs the CTA 500dm to return stored values.
The returned strings vary according to the value included in the
command. (See the possible values in the following table.) If no
value is speciÞed, the default value of 0 is used.
Parameters are displayed in alphabetical order using a maximum
width of 72 columns.
Value Returned strings
0 all stored profiles
1 all stored dial strings
4 all stored Caller ID Security numbers
OK Appears following display of the requested parameters.
ERROR Appears when the chosen value was invalid.
The Set Local Echo Command
instructs the CTA 500dm to turn the local AT command echo on or
off. A value of 0 turns the echo off and a value of 1 turns the echo
on. No value defaults to a value of 1.
OK Appears when the command was successful.
ERROR Appears when the chosen value was invalid.
&V[value]
E[value]
P0873832 Issue 05