Profile Commands Summary - Nortel CTA 500dm Installation Manual

30 AT commands
Profile
Profile commands summary
CTA 500 dm On Line Guide
A proÞle deÞnes a CTA 500dm set-up. Each proÞle deÞnes the rate
adaptation protocol and the options used with that protocol, the
bearer capability and data rate of the next call dialed, the bearer
capabilities and acceptable data rates for inbound calls, and the
detailed operation of the serial interface port.
The proÞle does not include stored dial strings.
Three types of proÞles are available:
¥ The factory default which is Þxed.
¥ The user proÞle which is programmable by the user and is stored
in non-volatile memory.
¥ The active proÞle which is dynamic while the CTA 500dm is in
operation. It records changes made using AT commands. When
the CTA 500dm is powered down, the active proÞle is lost, unless
it is saved as the user proÞle. On power-up, the active proÞle is
loaded from one of the saved proÞles.
The factory proÞle is proÞle 0 and the user proÞle is proÞle 1.
Command Description
&Fn load active profile
from factory profile
Zn load active profile
from stored profile
&Yn select profile to load
into active profile on power-up
&W save active profile to memory
Value
0 factory profile (default)
1 user profile
0 factory profile
1 user profile (default)
0 factory profile (default)
1 user profile
P0873832 Issue 05