Stihl MSA 160 C Instruction Manual page 94

English
Chain Lubrication
Fully automatic speed-controlled oil
pump with reciprocating piston
Oil tank capacity: 210 cc (0.21 l)
Weight
with bar and chain, without battery
MSA 160 C: 3.2 kg
MSA 200 C: 3.3 kg
Cutting Attachment
Rollomatic E Mini 1/4" Picco guide bars
MSA 160 C: 25, 30 cm
MSA 200 C: 25, 30, 35 cm
Pitch: 1/4" P (6.35 mm)
Groove width: 1.1 mm
Nose sprocket: 8-tooth
1/4" Picco chain
Picco Micro 3 (71 PM3) Type 3670
Pitch: 1/4" P (6.35 mm)
Drive link gauge: 1.1 mm
Chain sprocket
MSA 160 C: 7-tooth for 1/4" P
MSA 200 C: 6-tooth for 1/4" P
Noise and Vibration Data
Noise and vibration data are determined
on the basis of the rated maximum
speed.
92
For further details on compliance with
Vibration Directive 2002/44/EC see
www.stihl.com/vib/
Sound pressure level L to
p
EN 60745-2-13
MSA 160 C: 83 dB(A)
MSA 200 C: 84 dB(A)
Sound power level L to EN 60745-2-13
w
MSA 160 C: 94 dB(A)
MSA 200 C: 95 dB(A)
Vibration measurement a
hv
EN 60745-2-13
Handle, left Handle, right
2
MSA 160 C: 2.0 m/s 2.0 m/s
2
MSA 200 C: 4.5 m/s 4.0 m/s
The K-factor in accordance with
Directive 2006/42/EC is 2.5 dB(A) for
the sound pressure level and sound
power level; the K-factor in accordance
with Directive 2006/42/EC is 2.0 m/s
for the vibration measurement.
The vibration values quoted above have
been measured according to a
standardized test procedure and may be
used to compare electric power tools.
Depending on the type of usage, the
vibrations that actually occur may differ
from the values quoted.
The vibration values quoted may be
used for an initial assessment of the
user's exposure to vibrations.
The actual exposure to vibrations has to
be evaluated. This process may also
take into account times during which the
electric power tool is switched off and
times during which it is switched on but
running without load.
Transport
STIHL batteries fulfill the requirements
stated in UN-Manual
ST/SG/AC.10/11/Rev.5 Part III,
Subsection 38.3.
The user can transport STIHL batteries
by road transport to the place where the
machine is to be used without additional
requirements.
to
The lithium ion batteries included are
subject to the provisions of the
legislation relating to dangerous good.
2
When shipped by a third party (e. g. air
2
transport or haulage firm), special
packaging and identification
requirements must be observed.
When preparing the item for shipment, a
dangerous goods expert must be
2
consulted. Please observe any further
national regulations.
Pack the battery so that it cannot move
inside the packaging.
Further transport instructions - see
www.stihl.com/safety-data-sheets
REACH
REACH is an EC regulation and stands
for the Registration, Evaluation,
Authorisation and Restriction of
Chemical substances.
For information on compliance with the
REACH regulation (EC) No. 1907/2006
see www.stihl.com/reach.
MSA 160 C, MSA 200 C