Husqvarna TE 630 2011 I.E. Manual page 90

ADJUSTING THE FRONT FORK
a) REBOUND (TOP ADJUSTER)
Standard setting: - 12 clicks.
To reset standard calibration, turn adjuster (C) clockwise
to reach the fully closed position; then, turn it back by
the mentioned clicks. In order to obtain a smooth braking
action, turn the adjuster counter clockwise. Vice versa to
obtain a harder braking action.
b) AIR VENT (to carry out after each competition, or
monthly).
Set the motorcycle on a central stand, release the fork
fully extended and loosen the air vent valve (D). Once
this operation is over, tighten the valve.
Note *: Never force the adjusting screws
beyond the maximum open and closed posi-
tions.
EN - 32
FORK OIL LEVEL
For regular fork operation, both legs must be provided
with the necessary oil quantity. Remove the fork legs
from the fork to check the oil level. Work as follows:
- remove the damper rod caps;
- remove springs from the legs letting the oil drain into
the legs;
- bring fork to stroke end;
- check that the level is at distance "A" below the upper
limit of damper rod.
OIL QUANTITY IN EACH FORK LEG
- TE: 38.44 cu.in.
- SMS: 36.61 cu.in.
A=80mm (3.15 in.) - TE
C
A=90mm (3.54 in.) - SMS
D
Note *:
Flexibility index of the standard springs:
K=28.55 lb/in. (TE)
K=30.83 lb/in. (SMS)
Note *:
Always replace both the spring and the spacers to keep
the preload value unchanged.
A