Assembly; Hardware Drawing - NordicTrack ELITE 2900 0603.0 User Manual

ASSEMBLY

3/4" Tek Screw (58)–8
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrench
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags,
check to see if the part has been preattached. To avoid damaging plastic parts, do not use power tools for
assembly.
Nut (38)–2
Upright Bolt (72)–6
1. Identify the Left and Right Uprights (73, 74). The Left
Upright has two large holes in the indicated locations.
Set the Right Upright (74) near the Frame (48) as
shown. Insert the Upright Wire Harness (75) into the
lower end of the Right Upright and out of the top.
Place an elastic band around the Upright Wire Harness
(75) and the Right Upright (74) to keep the Upright Wire
Harness from falling into the Right Upright. Leave the
elastic band on until step 6.
1" Tek Screw (82)–4
Handrail Star
Upright Star
Washer (90)–6
Washer (71)–6
Handrail Bolt (64)–6
1/2" Screw (10)–3
and your own phillips screwdriver
3/4" Screw (79)–2
Washer (78)–6
Wheel Bolt (85)–2
1
48
Large Hole
6
Base Pad Spacer
(77)–4
Small
74
75 Holes
Band
Large Hole
73
.