NordicTrack VGR990 NTEL12900 User Manual page 6

1. Identify the Rear Stabilizer (59), which has Wheels (45)
attached to it.
Attach the Rear Stabilizer (59) to the rear of the Frame
(1) with the two Rear Stabilizer Bolts (60) and two M10
Nylon Locknuts (26). Make sure that the Rear
Stabilizer is turned so the Wheels (45) are not
touching the floor.
2. Attach the Front Stabilizer (14) to the front of the
Frame (1) with the two Front Stabilizer Bolts (86) and
two M10 Nylon Locknuts (26).
3. Slide an M8 Split Washer (58) and an M8 Washer (33)
onto an Incline Axle Screw (30). Tighten the Incline
Axle Screw into one end of an Incline Axle (29). Next,
apply a small amount of the included grease to the
Incline Axle.
Align the indicated tubes on the Incline Ramp (5) with
the tubes on the Base (1). Make sure that the Incline
Ramp is turned so the V-shaped grooves are on
top. Insert the Incline Axle (29) through the Incline
Ramp and the Base. Note: It may be helpful to tap the
Incline Axle with a rubber mallet to insert it.
Slide an M8 Split Washer (58) and an M8 Washer (33)
onto another Incline Axle Screw (30). Tighten the
Incline Axle Screw into the open end of the Incline Axle
(29).
4. Slide an M8 Split Washer (58) and an M8 Washer (33)
onto an Incline Axle Screw (30). Tighten the Incline Axle
Screw into one end of the other Incline Axle (29). Next,
apply a small amount of grease to the Incline Axle.
Raise the Incline Ramp (5). Insert the Incline Axle (29)
through one side of the Incline Ramp, through a 56mm
Spacer (22), through the end of the motor screw,
through another 56mm Spacer (22), and then through
the other side of the Incline Ramp.
Slide an M8 Split Washer (58) and an M8 Washer (33)
onto another Incline Axle Screw (30). Tighten the Incline
Axle Screw into the open end of the Incline Axle (29).
1
26
1
2
86
3
29
Grease
33
58
30
4
29
33
58
30
6
59
26
60
14
1
26
V-shaped Groove
5
33
Tubes
1
Tubes
58
33
22
Motor
Screw
Grease
45
26
58
30
30
5