Nortel Contivity 1700 Installing Manual page 66

66 Chapter 4 Installing option cards and DIMMs
10 Replace the top cover on the chassis (see
11 If the Contivity 1700 is installed in an equipment rack, mount it in the rack.
12 Replace the front bezel (see
314711-D Rev 00
a Hold the cover at an angle and slide it onto the chassis.
b Using a screwdriver, insert and tighten the 4 screws to secure the cover to
the chassis.
a
Set the Contivity 1700 on the rack-mount shelf in the rack.
b Insert one of the panhead screws through the bottom hole on each side of
the shelf into the hole in the rack and tighten the screws.
a
Hold the bezel by its two handles and push it onto the chassis.
b Using the screwdriver, tighten the 2 screws to secure the bezel to the
chassis.
Figure 18 on page
Figure 23 on page 63).
56).